3 Series E90 320i (N46T) SAL
34 00 050
Bleeding brake system with DSC
Note:
Read and comply with General Information.
When replacing or repairing, observe the filling and bleeding
instructions for the following parts:
-
Tandem brake master cylinder
-
Hydraulic unit
-
Components and connecting lines which are fitted
between these assemblies.
Connect bleeder unit with max. 2 bar filling pressure.
A second person is needed to help carry out this work.
Unclip retaining tabs (1).
Pull cover (3) out of guide (2) and remove.
Connect DIS.
Select path: Service functions - Chassis/Suspension - Slip control
systems - Bleeding procedure.
Connect brake fluid changer to expansion tank and switch on.
Important!
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleed valve.
Follow same procedure on rear left, front right and front left wheel
brake.
RA Bleeding brake system with DSC
BMW AG - TIS
27.01.2013 07:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -