3 Series E90 320i (N46T) SAL
Tightening torque 34 32 3AZ
.
Important!
Never twist brake hose when installing it and avoid all contact
with parts attached rigidly to the body.
Note:
First tighten brake hose on brake caliper.
Insert brake hose in bracket and screw onto brake pipe.
Lift out retaining spring (1).
Remove cover plug (1).
Pull brake pad wear sensor out of brake pad (right side only).
If necessary, replace brake pad wear sensor.
Unscrew guide bolts (1).
Remove brake caliper (2) by pulling forward.
Installation:
Tightening torque 34 21 4AZ
.
Clean guide screws only; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
RA Removing and installing or replacing rear left or right brake calliper (Teves)
BMW AG - TIS
27.01.2013 08:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -