3 Series E90 320i (N46T) SAL
Door cannot be opened if Bowden cable (1) is incorrectly
laid.
Important!
Do not damage door lock seal when removing.
Release screws (1).
Remove door lock (2) from inside.
Installation:
Pull door lock (2) with special tool into corner (3).
Important!
Observe the following notes on installation without fail in order
to avoid leakage and electrical malfunction.
Installation:
Seal (1) on door lock (2) must not be damaged.
E90/E91 driver's side only:
Note:
Cover (1) protects against water ingress.
In event of problems with frozen door locks/lock cylinders:
If necessary, retrofit cover (1) on door lock (2).
Installation:
-
Install door lock and insert screws (1), do not tighten down.
-
Slide special tool 51 2 190 into opened rotary latch until
latch engages in first stage.
RA Removing and installing/replacing door lock in left or right front door
BMW AG - TIS
27.01.2013 10:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -