3 Series E90 320Si (N45) SAL
Installation:
Replace sealing ring (2) on suction tube (1).
Note:
The special tool bore for the TDC position is located on the inlet
side underneath the starter motor.
Crank engine at central bolt and secure flywheel with special tool
11 5 120 .
Important!
Left-hand threads.
Release nut (1).
Press clamping rail (2) towards rear and secure with special
tool 11 3 340 .
Release screws (3).
RA Removing and installing/replacing oil pump (N45)
BMW AG - TIS
28.01.2013 07:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
