3 Series E90 325i (N52K) SAL
Normalization:
•
Press and hold the switch in the "Lift" direction
•
In the event of delayed starting or sudden stopping of the
slide/tilt sunroof, continue pressing the switch in the "Lift"
direction
•
After reaching the lift end position (A), keep the switch
pressed for approx. 15 seconds further
•
Normalization is completed when the slide/tilt sunroof in lift
end position (A) presses again briefly in the direction of
position (B).
Learning characteristic curve:
The curve is learnt manually in the following steps:
•
After normalization, keep switch pressed in "Lift" direction.
•
The slide/tilt sunroof stops for 5 seconds in the final raise
position after normalization. It then moves into the "Closed"
position (learning of the "Closing from raising" curve)
•
The slide/tilt sunroof then moves into the "Open" end position
and immediately back into the "Closed" position (learning of
the "Closing" curve)
•
Release switch.
Note:
•
The entire operation lasts approx. 75 secs.
•
Learning of the curve is terminated when the switch is
released
•
If the switch is released in the meantime, the entire procedure
must be repeated
•
On completion of successful initialization, the corresponding
messages in the check control and the control display go out
•
Carry out function check (tip function, anti-trapping protection
and, if necessary, comfort function)
RA Notes on steel and glass slide/tilt sunroofs (initialization/normalization/learn
BMW AG - TIS
09.02.2013 03:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -