3 Series E90 325i (N52K) SAL
Note:
Bumper trim shown removed for purposes of clarity.
Unlock catch (1) in direction of arrow.
Feed high-pressure nozzle (2) towards rear out of headlight
arm (3).
Unlock plug connection on high-pressure nozzle (2) and detach
high-pressure line from high-pressure nozzle (2).
Installation:
Keep plug connection for high-pressure nozzle and high-
pressure line clean and free from grease.
Ensure guide (2) is correctly seated.
Retaining lugs (1) must snap audibly into place.
Check function.
If necessary, adjustment can be carried out carefully using pointed
pliers (tape of front area with adhesive tape where necessary).
If necessary, top up washer fluid.
RA Removing and installing / replacing left or right high-pressure nozzle of headli
BMW AG - TIS
09.02.2013 05:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -