3 Series E90 325xi (N52) SAL
Adjust toe-in:
Clean thread on tie rod.
Loosen screw (2).
Turn tie rod (3) and if necessary grip tie rod end (1) to adjust
toe-in to setpoint value.
Tighten screw (2).
Tightening torque 32 21 2AZ
.
If necessary, correct installation position of gaiter.
Adjusting camber:
Remove tension strut for spring strut dome.
Remove protective cap.
Twist/drive out centering pin (1).
Clean wheel arch from below in area of support bearing with
compressed air.
Slacken nut (2).
Insert special tool 32 3 140 into opening in wheel arch.
Note:
The spindle 32 3 146 must be aligned in such a way that the
short end of the guide sleeve (3) points upwards.
Screw knurled nut 32 3 147 onto stud.
Replace nuts (1) and screw on but do not tighten down fully.
Turn nut (2) of special tool 32 3 140 to adjust camber to
setpoint value.
Tighten down nuts (1).
Tightening torque 31 31 1AZ
.
Remove special tool 32 3 140 .
Replace nut (1) and tighten down.
Tightening torque 31 31 1AZ
.
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
11.02.2013 14:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
