3 Series E90 325xi (N52K) SAL
Replace nut and tighten down with special tool 31 2 210 (grip
piston rod in the process).
Tightening torque 31 31 2AZ
.
Fit cover cap.
Important!
Spring pad (1) must rest positively on spring plate (2)!
Upper end of coil spring must rest on stop of spring pad (1)!
Important!
Lower end of coil spring (2) must rest on stop of spring
pad (1)!
Relieve tension on coil spring.
Check installation position of gaiter, correct fold if necessary.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Replacing front left or right spring strut (AWD)
BMW AG - TIS
13.02.2013 00:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
