3 Series E90 325xi (N52K) SAL
32 13 060
Removing and installing/replacing power
steering gear (AWD)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Remove tie rod end on both sides from swivel bearing
•
Replacement only: Remove tie rod end at both ends of tie rod
•
Lower front axle support
If necessary, remove heat shield from power steering gear.
Release banjo bolts (1, 4).
Disconnect pressure line (2) and return line (3) from power
steering gear.
Remove cooler return line from front axle carrier.
Installation:
Replace sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 9AZ
(pressure line).
Tightening torque 32 41 10AZ
(return line).
RA Removing and installing/replacing power steering gear (AWD)
BMW AG - TIS
13.02.2013 01:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -