3 Series E90 325xi (N52K) SAL
32 31 215
Removing and installing/replacing double
joint for steering spindle lower section (AWD)
Important!
If the double joint is separated from the power steering
gear/lower section of the steering spindle, the steering column
switch cluster may be damaged when the steering wheel is
turned.
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly
•
Secure upper section of steering spindle in footwell (can be
pushed into steering column)
•
N51, N52, N53, N54: Remove intake filter housing
Release clamping screw (1).
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of power steering gear.
No kinking permitted!
Tightening torque 32 31 3AZ
.
Release clamping screw (1).
Return steering to straight-ahead drive setting and remove ignition
key.
Pull steering spindle lower section (3) from double joint (4).
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove (2) of steering spindle lower
section (3).
No kinking permitted!
RA Removing and installing/replacing double joint for steering spindle lower sectio
BMW AG - TIS
13.02.2013 01:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
