3 Series E90 325xi (N53) SAL
Unlock plugs (1) using slide in direction of arrow and disconnect.
Short plug:
Unlock slide (2) in bore holes (1) and pull out of housing.
Unlock tab (3), pull contact carrier (4) in direction of arrow out of
housing.
Long plug:
Press locking tab (1) in direction of arrow and pull contact
carrier (2) out of housing.
Unlock and disconnect all plug connections of engine wiring
harness section in electronics box.
Work step
Note:
Unlock plug connections on control sensors and disconnect
Unlock plug on alternator and disconnect
Unlock plug connection on knock sensors and disconnect
Unlock plug on crankshaft sensor and disconnect
Unlock plug on starter motor and disconnect
Cable routing behind fuel line
Unlock plug on high-pressure pump and disconnect
Unlock plug on low-pressure sensor and disconnect
Unlock plug on exhaust-gas recirculation valve and disconnect
Unlock vacuum line on tank vent valve and disconnect
Unlock plug on A/C compressor and disconnect
RA Replacing wiring harness section for engine (N54)
BMW AG - TIS
14.02.2013 18:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -