3 Series E90 325xi (N53) SAL
Seal fuel lines with special tools 13 5 281 and
13 5 282 .
Slacken nut (1).
Release screw (2).
Remove feed line (3).
Close off feed line and high-pressure pump with a matching plug
from special tool kit 32 1 270 .
Installation:
Feed lines with soldered holder must be replaced by new version
with elastomer clamp holder. Observe installation position of fuel
low-pressure sensor. Lines for solenoid switches are laid behind
fuel line.
Install feed line (3).
In so doing, tighten screw connection hand-tight only
Important!
Follow sequence of screw connections:
1.
Tighten down nut (1) with special tool 13 5 020 .
Tightening torque 13 53 6AZ
.
RA Removing and installing/replacing feed line (N54, N53)
BMW AG - TIS
14.02.2013 18:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
