3 Series E90 325xi (N53) SAL
Release flexible disk screws at rear.
Installation:
Replace ZNS bolts and nuts.
Tighten down screws/bolts to specified torque.
Secure special tool angle of rotation 00 9 120 with magnet
00 9 130 to underbody and continue bolting according to angle
of rotation.
Tightening torque: 26 11 4AZ
.
Grip propeller shaft at centre mount and release screws.
Tightening torque: 26 11 6AZ
.
Detach propeller shaft from transmission output flange and
remove towards bottom.
Installation:
Check centring mount.
If necessary, replace damaged centring mount.
Grease centring mount.
-
Grease: BMW Service Operating Fluids.
RA Removing and installing complete propeller shaft
BMW AG - TIS
14.02.2013 20:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -