3 Series E90 325xi (N53) SAL
Installation:
Expand swivel bearing with special tool 31 2 230 , align by way
of gap to positioning pins (1) on back of spring strut and raise up
to stop.
Centering pin missing: Make position of studs in relation to wheel
arch.
Secure spring strut against falling out.
Unscrew nuts (1).
Remove spring strut downwards out of wheel arch.
Installation:
Clean contact surface in spring strut dome.
Align spring strut using centering pin to bore in wheel arch or
studs to wheel arch and push upwards.
Replace self-locking nuts.
Tightening torque 31 31 1AZ
.
Important!
Replace faulty sealing washer (1).
Reinstall sealing washer (1) and plate insert (2).
After installation:
•
Carry out chassis/wheel alignment check if a spring strut with
support bearing was or has been installed without centering
pin.
RA Removing and installing complete front left or right spring strut (AWD)
BMW AG - TIS
14.02.2013 20:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -