3 Series E90 325xi (N53) SAL
64 51 591
Removing and installing/replacing evaporator
Necessary preliminary tasks:
•
Remove heater/air conditioner
Carefully pull rubber grommet (1) and foam seal (2) over
pipes (3) and (4).
Note:
If necessary, replace rubber grommet (1) and/or foam seal (2).
Release screws (5).
Unfasten plug connection (1) and disconnect.
Carefully remove seal (2) and all remnants.
Installation:
Replace seal (2).
Turn temperature sensor for cold-air distributor (3) in direction of
arrow and detach in upwards direction. Expose connecting
cable (4) of temperature sensor for cold-air distributor (3)
towards rear of heater/air conditioner (5).
Release screws (1).
Remove upper housing (2) of heater/air conditioner in direction of
arrow.
Installation:
Make sure upper housing (2) is correctly seated on heater/air
conditioner.
RA Removing and installing/replacing evaporator
BMW AG - TIS
15.02.2013 06:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -