3 Series E90 328i (N51) SAL
Important!
After removing, pack magnet wheel (1) away immediately in
a plastic bag (2) for safety reasons.
Magnet wheel must be protected against metal chips.
Pretension eccentric shaft (1) upwards in direction of arrow.
Remove min stop screw between 1st and 2nd cylinders.
Tightening torque: 11 37 6AZ
.
Release screws (1).
Tightening torque: 11 12 3AZ
.
Screw (2) can only be released when the chain module is
pressed forward slightly.
Important!
Secure screw (2) with a gripper against falling out and
remove.
Installation:
Replace aluminium screws.
Important!
Different screw heads
M 10 screw (1) is released with special tool 11 8 580 .
M 9 screw (2) is released with special tool
11 4 420 .
Note:
Illustration shows camshaft removed.
RA Removing and installing/sealing cylinder head (N51)
BMW AG - TIS
16.02.2013 03:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
