3 Series E90 328xi (N52K) SAL
23 12 088
Replacing radial shaft seal for selector shaft
(GS6-37BZ/DZ H-transmission)
Special tools required:
•
23 0 210
•
23 0 220
Important!
After completion of work, check transmission fluid level.
Use only approved transmission oil.
Failure to comply with this instruction will result in serious
damage to the transmission.
Necessary preliminary tasks:
•
Remove exhaust system.
•
Remove underbody protection
•
Remove heat shields
•
Shift transmission into 2nd gear
•
Unflange propeller shaft from transmission and tie to one side
•
Remove transmission cross-member
Lever retaining ring (1) out of groove with a small screwdriver.
Slide locking ring (1) towards rear.
Drive out cylinder pin (2).
RA Replacing radial shaft seal for selector shaft (GS6-37BZ/DZ H-transmission)
BMW AG - TIS
18.02.2013 00:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
