3 Series E90 328xi (N52K) SAL
34 11 020
Removing and installing or replacing front left
or right brake calliper (Teves)
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
Necessary preliminary tasks:
•
Remove wheels.
•
Read and comply with General Information.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
If necessary, pull brake hose out of holder (1).
Important!
Grip brake hose at square head (3) to prevent connecting
piece from turning in retaining bracket.
Disconnect brake hose from brake line (2).
Installation:
Tightening torque 34 32 1AZ
.
Detach brake hose from brake caliper (4).
RA Removing and installing or replacing front left or right brake calliper (Teves)
BMW AG - TIS
18.02.2013 04:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
