3 Series E90 330d (M57T2) SAL
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Relieve tension on clutch slave cylinder slowly; otherwise air
will be drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
Unlock plug (1) from reversing light switch and detach.
Release cable from retainers.
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
RA Removing and installing transmission (GS6-53DZ) (M57T2)
BMW AG - TIS
18.02.2013 19:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
