3 Series E90 330d (M57T2) SAL
Release hose clamp (1) and detach suction line (2) from vane
pump.
Installation:
Markings on suction line and vane pump connection must match
up.
Release banjo bolt (3) and disconnect pressure line (4).
Installation:
Replace all sealing rings (D).
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 8AZ
.
Release bolts (1) and remove vane pump (2).
Tightening torque 32 41 5AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing/replacing vane pump for power steering (M47T2, M57T2)
BMW AG - TIS
18.02.2013 21:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
