3 Series E90 330i (N53) SAL
64 12 ...
Initializing Telestart hand transmitter (T90)
(up to build date 03/2007)
Note:
The Telestart hand transmitter must be initialized when:
•
Hand transmitter is replaced
•
Car Access System control unit is replaced
The independent heating is switched on under an outside
temperature of approx. 15
°
C with the hand transmitter and at a
preselected switch-on time.
Direct activation is possible at any outside temperature via the
"Climate" menu item in the i-Drive, but not in driving mode.
To initialize a new hand transmitter, perform the following
operations from inside the vehicle:
•
Close all vehicle doors
•
Within 5 seconds: Switch ignition lock from terminal "0" to
terminal "R" and then back to terminal "0"
•
Within 5 seconds: Press OFF button (1) on hand transmitter
and with OFF button (1) held down press ON
button (2) three times quickly
•
Release both buttons. LED (3) on hand transmitter flashes
Note:
The vehicle's central locking closes and opens automatically on
successful initialization.
The initialization process must be repeated if there is no
checkback signal from the central locking system.
RA Initializing Telestart hand transmitter (T90) (up to build date 03/2007)
BMW AG - TIS
20.02.2013 09:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
