3 Series E90 330xd (M57T2) SAL
Important!
Fit screw cap without using a tool and tighten hand-tight.
Then tighten screw cap with special tool 16 1 020 until
notch (1) points to marking (2).
Note:
Illustration shows the tank removed.
Carefully lift sensor unit (1) out of tank.
In so doing, press tab (2) against spring force in order to make it
easier to feed sensor unit out of tank.
Note:
Illustration shows the tank removed.
Installation:
Clean sealing faces and install new rubber sealing ring.
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
Make sure that the lever sensor moves freely before fitting the
service cap.
Remove sensor unit (1) and hose pack (2) with auxiliary cable to
left.
Installation:
When replacing the sensor unit, modify the end of the auxiliary
lead to the new hose pack and carefully pull in through the tank.
Note:
Illustration shows the tank removed.
RA Removing and installing or replacing fuel gauge sensor (diesel, left)
BMW AG - TIS
20.02.2013 10:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
