3 Series E90 330xd (M57T2) SAL
31 35 000
Removing and installing/replacing front
stabilizer (AWD)
Important!
To avoid complaints being made by the customer about noise,
set the car on its wheels and tighten down the stabilizer
mounting to specified torque.
Necessary preliminary tasks:
•
Remove front assembly underside protection
•
Remove stabilizer link on both sides from stabilizer
Note:
The following illustrations was created using the E91 with M57T2
as an example. Other vehicles and engines may show differences
in detail.
N52:
Remove coolant pipe from front axle carrier.
Release screws (1).
Remove bracket (2) with pressure line for power steering from
front axle carrier.
Remove stabilizer (3).
Installation:
Check rubber mount on both sides, replace if necessary.
RA Removing and installing/replacing front stabilizer (AWD)
BMW AG - TIS
20.02.2013 12:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -