3 Series E90 330xd (M57T2) SAL
M57T2:
Disengage vacuum line for engine mount on front axle carrier.
Lower front axle carrier further.
Note:
Heat shield is only fitted on the right side.
If necessary, release screws (1) and remove heat shield (2).
Tightening torque 32 21 4AZ
.
Release nuts and remove screws (1) towards bottom.
Remove power steering gear (2) to one side.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
RA Removing and installing/replacing power steering gear (AWD)
BMW AG - TIS
20.02.2013 13:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -