3 Series E90 330xi (N53) SAL
17 22 010
Removing and installing/replacing heat
exchanger for automatic transmission
Drain off and top up coolant.
Recycling
Transmission fluid emerges when oil lines are detached from heat
exchanger.
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations.
Important!
Check fluid level in automatic transmission, refer to
Maintenance and General Information HG00.
Press lines (1/2) in direction of heat exchanger and pull locking
ring towards rear.
Keep locking ring pressed and detach lines (1/2) from heat
exchanger.
Release screw on heat exchanger.
RA Removing and installing/replacing heat exchanger for automatic transmission
BMW AG - TIS
20.02.2013 22:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
