3 Series E90 335d (M57T2) SAL
11 14 151
Replacing rear crankshaft seal (M57T2)
Necessary preliminary tasks:
•
Drain off engine oil
•
Remove flywheel
Unfasten oil sump screws on transmission end.
Loosen oil pan.
Release bolt (2) and remove crankshaft sensor (3) in direction
of arrow.
Remove sensor gear.
Release bolts (1) and remove end cover.
Important!
Check oil sump gasket for damage after removing end cover.
If necessary, remove oil sump and replace oil sump gasket.
Note:
Illustration does not show oil sump.
Lubricate contact face of crankshaft.
Important!
When mounting the end cover with crankshaft seal on the
crankshaft, only the "support bushing (1)" may be used as an
installation tool.
Push on end cover with support bushing (1) straight and
without tilting sideways.
Insert all screws and tighten down end cover.
Note:
RA Replacing rear crankshaft seal (M57T2)
BMW AG - TIS
21.02.2013 06:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
