3 Series E90 335d (M57T2) SAL
Release screws (1) and remove cover (2) from right side of fuel
tank.
Disconnect plug connection (1).
If necessary, remove fuel line for independent heating.
Release screw cap with special tool 16 1 020 and remove
service cap.
Installation:
Procedure for tightening screw cap, see next work step.
Important!
Fit screw cap without using a tool and tighten hand-tight.
Then tighten screw cap with special tool 16 1 020 until
notch (1) points to marking (2).
Note:
Illustration shows the tank removed.
RA Removing and installing or replacing fuel gauge sensor (diesel, right)
BMW AG - TIS
21.02.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
