3 Series E90 335i (N54) SAL
Insert piston with conrod in cylinder.
Important!
Risk of damage to oil spray nozzle.
Danger of piston ring failure.
Press in piston in direction of arrow with finger pressure only,
do not drive in.
Insert piston so that arrow on piston crown points to camshaft
drive.
Press in piston (1) with special tool 11 8 141 .
Important!
Conrod and conrod bearing cap are identified with pairing
letters (1) and must not be mixed up.
Mixing them up or incorrectly fitting the conrod bearing cap on
the big end will result in engine damage.
Apply a light coat of oil to crank pin.
Assemble conrod and crank pin.
Screw off special tool 11 8 560 in counterclockwise direction.
Fit bearing caps (2) so that pairing letters match up.
Install new conrod bolts (1).
Tightening torque: 11 24 1AZ
RA Removing and installing/replacing all pistons (N54)
BMW AG - TIS
22.02.2013 03:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -