3 Series E90 335i (N54) SAL
Prepare special tool (1) 24 4 161 (A) with shaped section (2)
24 4 165 side (B) to (A).
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Raise by turning screw (2) and clamp down.
Then tighten down screw (1).
•
Unlock and disconnect plug (1) by turning.
•
Do not touch pins.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
Operations are described in
Notes on mechatronics
Important!
Read and comply with important note.
Release screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws 24 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation, aluminium screws/bolts
24 00 2AZ
(3, 4, 5, 9, 10).
RA Removing and installing automatic transmission (GA6HP19Z) N54
BMW AG - TIS
22.02.2013 05:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -