3 Series E90 335xi (N54) SAL
Installing inner gaiter:
Push gaiter with cap onto output shaft (1).
Mount special tool 33 2 100 with corresponding shell inserts on
output shaft (1).
Press joint (2) over bearing inner race onto output shaft.
Install new circlip (1).
Important!
Keep sealing faces of cap and joint (on both sides) clean and
free from grease.
Fill joint at both ends with high-temperature grease.
Important!
Risk of damage!
Do not install gaiter with cap and sealing cover on joint without
shims.
RA Replacing both gaiters on left or right output shaft (on 2-flow exhaust system)
BMW AG - TIS
22.02.2013 15:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
