3 Series E90 335xi (N54) SAL
If necessary, position special tool 00 2 040 with a 2nd person
helping on workshop jack 00 2 030 .
Insert special tools 33 4 491 and 33 4 492 into corresponding
mountings of special tool 00 2 040 .
Lower special tool 33 3 274.
Note:
The jacking points on the left side are shown.
Align special tools 33 4 491 and 33 4 492 to rear axle carrier.
Support rear axle carrier by operating workshop jack 00 2 030 .
Remove compression struts (1).
Release screws (2) and swivel/remove stop plates to one side.
Lower rear axle carrier.
Installation:
Check threads for damage; if necessary, repair with Helicoil thread
inserts.
First install compression struts (1) and then tighten down
screws (2).
Tightening torque 33 33 1AZ
.
After installation:
•
Bleed braking system
RA Lowering/raising rear axle carrier (special tool SWZ00-2040)
BMW AG - TIS
22.02.2013 15:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -