3 Series E91 318i (N46) TOUR
Crank engine at vibration damper in direction of rotation until
screw is visible in opening.
Release all bolts (1) of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 2 bolts.
Tightening torque 24 40 1AZ
.
Supporting transmission:
Support with special tools 24 5 306 , 24 5 301 and 00 2 030 .
Set up special tool 24 5 306 :
-
All supports to "A".
-
Supports 3 and 4 are at rear of transmission.
-
Support lettering points forwards.
Unfasten screws (1) and nuts (2).
Remove transmission cross-member.
Tightening torque 24 71 1AZ/2AZ
.
Release bolts (3) and remove exhaust system bracket.
Lower engine towards rear, lock between oil sump and steering
with a suitable block (1) or workshop jack.
RA Removing and installing automatic transmission (6HP19Z) N46
BMW AG - TIS
21.01.2013 02:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
