3 Series E91 318i (N46T) TOUR
Cylinder head, front:
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Cylinder head, rear (exhaust side):
Note:
Illustration with engine removed.
Remove all sealing remnants from sealing surfaces of cylinder
head.
As illustrated, apply a sealing bead with Drei Bond 1209 (refer
to BMW Parts Service).
Cylinder head, rear (inlet side):
Remove all sealing remnants from sealing surfaces of cylinder
head.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Note:
Illustration with engine removed.
Note different version of screws (1 to 3).
Fit cylinder head cover and install all screws still without
pretension.
RA Removing and installing/sealing cylinder head cover (N46T)
BMW AG - TIS
21.01.2013 20:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -