3 Series E91 318i (N46T) TOUR
Crank engine at vibration damper in direction of rotation until
screw (1) is visible in opening.
Release all screws of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 5 bolts.
Tightening torque 24 40 1AZ
.
Prepare special tool (1) 24 4 161 with shaped piece (2)
24 4 165 .
Insert special tool 24 4 160 into opening of transmission
housing and tighten down slightly with screw (1).
•
Unlock and disconnect plug (1) by turning.
•
Do not touch pins.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
Operations are described in
Note on mechatronics
Important!
Read and comply with important note.
RA Removing and installing automatic transmission (GA6L45R) N45T, N46T
BMW AG - TIS
21.01.2013 22:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -