3 Series E91 320i (N43) TOUR
Installation
Important!
Risk of mixing up parts.
Exhaust and inlet adjustment units are different.
Mixing up exhaust and inlet adjustment units or installing an
exhaust or inlet adjustment unit of another engine variant will
result in engine damage.
1.
Exhaust adjustment unit (1) is marked with AUS and EX.
2.
Inlet adjustment unit (2) is marked with EIN and IN.
Note:
Position of inlet adjustment unit (2) to timing chain can be freely
selected.
Lift timing chain and hold under tension.
Fit sensor gear (1) on inlet adjustment unit (2) and feed in
together.
Replace screw.
Install bolt (1) of inlet adjustment unit and initially tighten without
play.
Note:
Position of exhaust adjustment unit (1) to timing chain can be
freely selected.
Lift timing chain and hold under tension.
Fit sensor gear (2) on exhaust adjustment unit (1) and feed in
together.
RA Removing and installing/replacing inlet and exhaust camshaft adjustment units (N
BMW AG - TIS
24.01.2013 07:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -