3 Series E91 320i (N43) TOUR
Unlock and detach all plugs (1 and 2).
Unlock carrier plate (1) and raise in direction of arrow. Unplug the
two plug connections on the left.
Unlock tabs (1) and remove sliding safety catch (2) in direction
of arrow.
Unlock tab (3) in direction of arrow and slide out plug (4) in
direction of arrow.
Withdraw profile seal from electronics box.
Installation:
To ensure leak-tightness, make sure profile seal is correctly
seated in electronics box.
Pull wiring harness (1) at rubber pieces (2) from holder.
RA Replacing section of wiring harness for transmission/lambda control (N43)
BMW AG - TIS
24.01.2013 08:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
