3 Series E91 320i (N43) TOUR
Crank engine at vibration damper in direction of rotation until
screw (1) is visible in opening.
Release all screws of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 5 bolts.
Tightening torque 24 14 1AZ
.
Prepare special tool (1) 24 4 160 (A) with shaped section (2)
24 4 165 side (A) to (A).
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Raise by turning screw (2) and clamp down.
Then tighten down screw (1).
Lower transmission and lock with a suitable block (1) between
steering and oil sump.
RA Removing and installing automatic transmission (6HP19Z) N43
BMW AG - TIS
24.01.2013 09:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -