3 Series E91 320i (N46) TOUR
Lift out retaining spring (1).
Remove cover plug (1).
Important!
Tie brake caliper back and do not allow to hang from brake
hose.
Unscrew guide bolts (1).
Remove brake caliper (2) by pulling forward.
Installation:
Tightening torque 34 21 4AZ
.
Clean guide screws only; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Remove outer brake pad.
Inner brake pad is located with its spring in the piston.
Important!
Mark any worn brake pads.
In the event of one-sided brake pad wear, do not change
brake pads round.
Clean brake pads.
Do not grease backs of brake pads sleeve.
RA Removing and installing or replacing brake pads on both rear disc brakes (Teves
BMW AG - TIS
25.01.2013 09:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -