3 Series E91 320i (N46T) TOUR
Previous clutch release bearing:
Clutch release bearing with rigidly positioned thrust plate (1).
Swivel motion of thrust plate (1) not possible.
Withdraw release lever (4) from spring wire clip (5) and remove.
Installation:
Clean release lever.
Note:
Illustration similar.
Apply a thin coating of grease to release lever at sliding
surfaces (1 and 2) only.
Grease, refer to BMW Service Operating Fluids.
Installation:
Check spring wire clip (5) and ball pin (6) for damage and
replace if necessary.
Apply a thin coating of grease to ball pin (6).
Grease, refer to BMW Service Operating Fluids.
Note:
The spring wire clip and ball pin must always be replaced on
the S6S 420G transmission.
Illustration similar.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
26.01.2013 07:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -