3 Series E91 320i (N46T) TOUR
Important!
Do not under any circumstances tighten down collar nut
beyond marker points in order to avoid damaging the
clamping sleeve.
Tighten down collar nut (1) to point where marker points are
aligned.
Drive in new retaining plate with following special tools (depending
on rear differential) as far as it will go.
-
168L / 188L / 188LW: Use special tools 00 5 500 and
33 3 480
-
215L / 215LW / 215 with lock: Use special tools 00 5 500
and 33 3 490
After installation:
•
Correct rear differential fluid level
RA Replacing shaft seal for input flange on rear differential
BMW AG - TIS
26.01.2013 09:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -