3 Series E91 320i (N46T) TOUR
41 14 511
Replacing complete rear left wheel arch (rear
left side panel removed)
Read contents of Body, General.
Refer to the description texts of the KSD CD (FRU 41 14 511)
for details of stripping-down and rigging work.
Remove or cover those vehicle components in the repair area
which are susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific
procedure.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Following new body parts are required (refer to EPC):
-
(1) C-pillar reinforcement
-
(2) Wheel arch, outer, rear
-
(3) Support, wheel arch
-
(4) Wheel arch, rear, inner half
-
(5) Support, frame side member
-
(6) Rear entrance shaped part (not shown)
Secure door opening at spot-welding flanges with strut (1) (refer
to Workshop Equipment & Planning CD, Chapter 7).
RA Replacing complete rear left wheel arch (rear left side panel removed)
BMW AG - TIS
26.01.2013 11:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -