3 Series E91 320i (N46T) TOUR
52 26 ...
Removing and installing/replacing all guide
sleeves for rear head restraints
Special tools required:
•
52 0 070
Necessary preliminary tasks:
•
Remove head restraint from rear seat
Note:
Guide sleeves cannot be removed without being damaged.
Guide sleeves with locks have two retaining lugs.
Insert special tool 52 0 070 into guide hole of sleeve (2) up to
upper area of retaining lug.
Feed release tongue of special tool into rear gap on retaining
lug (1).
Turn tool to release sleeve (2) and pull out towards top.
If necessary, on guide sleeves with locks, unlock the second
retaining lug with a screwdriver.
Installation:
Replace guide sleeves and install as follows:
1.
Short guide sleeves, middle right
2.
Short guide sleeve with lock, middle left
3.
Long guide sleeve, outer right
4.
Long guide sleeves with locks, outer left
RA Removing and installing/replacing all guide sleeves for rear head restraints
BMW AG - TIS
26.01.2013 14:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -