3 Series E91 320i (N46T) TOUR
54 10 175
Removing and installing rear glass slide/tilt
sunroof cover
Note:
The following steps can be carried out inside the vehicle with the
glass roof panel fully closed.
Open floating roofliner fully.
Make sure that grease at the ends of the rail do not come into
contact with the roofliner.
Not necessary for replacement:
Before removing the Torx screws, make a mark around the
washers in order to ensure correct alignment during installation.
Remove and dispose of the Torx screws (1) securing the glass
panel to the mechanism.
Installation:
Insert new Torx screws with Loctite and align washers to
markings.
Tightening torque 54 12 01AZ
.
Important!
A second person is required to help in removing and installing
the glass slide/tilt sunroof lid!
Lift out glass slide/tilt sunroof cover (1).
Installation:
Tape off complete edge area at roof aperture with fabric adhesive
tape (risk of damage).
Install glass slide/tilt sunroof cover carefully (twist in) as seal can
be damaged during installation.
Check glass slide/tilt sunroof cover for correct alignment and
adjust if necessary.
RA Removing and installing rear glass slide/tilt sunroof cover
BMW AG - TIS
26.01.2013 14:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -