3 Series E91 320i (N46T) TOUR
54 13 055
Replacing seal for slide/tilt sunroof frame
Necessary preliminary tasks:
•
Remove glass slide/tilt sunroof lid at rear
•
Lower (open) glass slide/tilt sunroof lid at front
Note:
Follow repair instructions for bonded seals on glass slide/tilt
sunroof.
Pull off seal of sunroof cut-out at contact edge starting from body.
(Peel off)
Installation:
Clean bonding surface with adhesive remover (sourcing
reference: BMW Parts Service).
Press seal without stretching (squashing).
Stick on seal in sections.
Establish seal joint.
Important!
Do not touch bonding surface.
Surface temperature
≥
20
°
C
Incorrect bonding of the seal will result in leakage.
RA Replacing seal for slide/tilt sunroof frame
BMW AG - TIS
26.01.2013 14:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -