3 Series E91 320i (N46T) TOUR
54 13 070
Removing and installing/replacing both
floating roofliners for glass slide/tilt sunroof
Necessary preliminary tasks:
•
Remove glass slide/tilt sunroof lid at front and rear
Note:
Front and rear floating roofliners can be removed separately from
each other.
Make sure that grease on the rails does not come into contact with
the floating roofliner.
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 minutes (start
of curing)
•
Microencapsulated screws must not be retightened
•
Clean thread of nut beforehand in event of repeated use
Front floating roofliner:
Open floating headliner approx. halfway.
Front rain channel must be situated between first and second
screws.
Release screws (1).
Tightening torque 54 12 04AZ
.
Remove star shims.
Installation:
Replace microencapsulated screws.
Make sure star shims are correctly positioned.
Pull out floating roofliner (2) in direction of arrow.
If necessary, press wind deflector downwards.
Installation:
Carefully raise floating roofliner mechanism.
RA Removing and installing/replacing both floating roofliners for glass slide/tilt
BMW AG - TIS
26.01.2013 14:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -