3 Series E91 320i (N46T) TOUR
61 35 714
Removing and installing/replacing control
unit for slide/tilt sunroof
Important!
Read and comply with notes on protection against
electrostatic discharge (ESD protection).
Necessary preliminary tasks:
•
Remove both trim panels for roof pillars at rear
•
Remove both rear grab handles
Version with dividing net mounts (1):
Fold back cover (2) for dividing net mount (1).
Release screw (3) and remove dividing net mount (1).
Installation:
Observe position indications on reverse side of dividing net
mount (1).
Important!
Do not kink roofliner under any circumstances!
Pull off muckets of rear lid and rear doors in roof area.
Unclip roofliner (1) in middle area downwards and lower.
Installation:
Holder (2) for roofliner (1) must be replaced.
RA Removing and installing/replacing control unit for slide/tilt sunroof
BMW AG - TIS
26.01.2013 15:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -