3 Series E91 320i (N46T) TOUR
65 24 020
Removing and installing or replacing blocking
circuit
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove both trim panels for roof pillars at rear
•
Remove rear left interior light
•
Remove rear left grab handle
Important!
Do not kink roofliner under any circumstances!
Pull off muckets of rear lid and rear doors in roof area.
Unclip roofliner (1) in middle area downwards and lower.
Installation:
Holder (2) for roofliner (1) must be replaced.
Version with dividing net mounts (1):
Fold back cover (2) for dividing net mount (1).
Release screw (3) and remove dividing net mount (1).
Installation:
Observe position indications on reverse side of dividing net
mount (1).
RA Removing and installing or replacing blocking circuit
BMW AG - TIS
26.01.2013 17:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -