3 Series E91 320i (N46T) TOUR
Cut front sticking surface in area on sensor mat (1) with cutter
knife or razor blade from foam without damaging the foam.
Remove sensor mat (1) and feed out electric lead.
Installation:
In order to guarantee the function and fastening (adhesive
strength) at the sticking surfaces of sensor mat (1), the foam
most not show any traces of damage at all!
Replace the foam if it is hardened or damaged particularly in the
area of the sticking surfaces.
Align new sensor mat (1) to upholstered seat section.
First guide cable through upholstered seat section in area (2).
Secure sensor mat in area (3) and align again.
Pull off adhesive strips in area (4) and stick to upholstered seat
section.
RA Replacing sensor mat for front passenger seat occupancy detector
BMW AG - TIS
26.01.2013 17:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -