3 Series E91 325xi (N52) TOUR
Preparation of new part:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Mark severance cuts (1) in accordance with measurement and
cut.
Important!
Cut outer metal sheet only.
Measurement a=170 mm
Measurement b = 110 mm
Installation:
Weld in reinforcement plates at severance cuts.
Preparation of new part:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (2).
Installation:
The parts separated by cutting are still needed.
Preparation of new part:
Open weld joints in areas (1).
Mark severance cut (2) in accordance with vehicle and cut.
Important!
Cut outer metal sheet only.
Preparation of new part:
Carry over the work step shown symmetrically to the other side of
the vehicle.
Open weld joints in areas (1).
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
10.02.2013 02:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -