3 Series E91 325xi (N52) TOUR
Preparation of new part:
Open weld joints in areas (1).
Installation:
The parts (2) separated by cutting are still needed.
Preparation of new part:
Open weld joints in area (1).
Mark severance cut (2) in accordance with vehicle and cut.
Installation:
Adjust new parts to fit with straightening attachment or universal
mount.
Before welding in, also adjust tail panel, rear lid and rear lights to
fit.
Weld new components in following order:
-
(1) Rear axle carrier
-
(2) Luggage compartment floor, upper section
-
(3) Support, frame side member
-
(4) Wheel arch, rear, inner half
Note:
Rear parcel shelf of Saloon and Coupé is shown removed for
purposes of clarity.
Installation:
For reasons of accessibility, the repair joining sequence differs
from the standard joining sequence.
Fit new component from above in area (1), adjust to fit and weld.
RA Replacing luggage compartment floor (complete with both inner wheel arch section
BMW AG - TIS
10.02.2013 02:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -